Pro Introduction
Everything you need to run your DEKORK lamp
Connect the lamp, control it with the Wi-Fi app or the physical remote, install updates, and solve common issues — all in one clear structure instead of scattered collapsed panels.
Getting Started
Connect directly to the lamp, or optionally add it to your Home Wi-Fi.
1.1 Direct connection via DEKORK Wi-Fi
No Home Wi-Fi required. The lamp broadcasts its own network so you can control it straight from your phone.
Turn on the lamp
Plug it in and wait a few seconds for the controller to start.
Connect to DEKORK-XXXXXX
Open the Wi-Fi settings on your phone and select the network created by the lamp.
Open 192.168.4.1
Enter the address directly in the browser address bar — the control app opens right on your phone.
1.2 Connect to Home Wi-Fi
This lets your phone stay online, enables the local .local address, supports multiple lamps, and allows firmware updates.
Open System
Tap the System tab at the bottom of the app.
Open Home Wi-Fi Setup
Scroll to Home Wi-Fi, tap the setup button and select your 2.4 GHz network.
Enter the password and connect
Wait until the lamp confirms that it is connected successfully.
Reconnect your phone to Home Wi-Fi
Return to your phone's Wi-Fi settings, reconnect to the same Home Wi-Fi network, then open http://A1B2C3.local in the browser.
Control with the Wi-Fi App
Light, bubbles, OLED and system settings — all in one app.
Light Controls
Choose color, brightness, effect speed and one of eight lighting effects.
Bubble Controls
Use the power switch, output slider and Standard, Pulse or Burst modes.
OLED Display
Turn the OLED on or off and choose one of the six display styles.
System Controls
Manage master power, physical remote, auto-off timer, firmware updates, Home Screen installation, Home Wi-Fi and lamp switching.
Control with the Physical Remote
Quick control without opening the Wi-Fi app.
3.1 One Remote, Three Systems
The printed button names are based on the original LED remote. On your DEKORK lamp, several timer buttons have additional functions.
Turn the Lamp On or Off
Turn On the System
Turns on the complete lamp system, including lighting, bubble system and OLED, according to saved settings.
Turn Off the System
Turns off the complete lamp system. Your previous settings remain saved for next time.
Change the OLED Screen
Cycle Through OLED Modes
Press repeatedly to switch to the next OLED display style, including OLED Off.
Control Bubble Output
Decrease Output
Reduces bubble pump power by 5% with each press.
Increase Output
Increases bubble pump power by 5% with each press.
Change Pump Mode
Cycles through the available bubble modes, including Bubble Off.
Adjust Brightness
Brightness Up
Increases LED brightness.
Brightness Down
Decreases LED brightness.
Select a Lighting Effect
Flash
Fast color-changing effect.
Fade
Colors fade gradually.
Smooth
Smooth color transitions.
White Light
Selects white lighting.
Select a Color
Press any colored button to immediately switch the lamp to that fixed color.
Updates & Troubleshooting
Firmware updates and solutions to common problems.
Firmware Update
Connect the lamp to Home Wi-Fi with Internet access, then use Firmware Update in the System tab.
App & Connection Troubleshooting
192.168.4.1 does not open
Verify that the phone is connected to DEKORK-XXXXXX and enter the address directly instead of searching for it.
The .local address does not open
Use the Home Wi-Fi IP shown in System, or reconnect directly and use 192.168.4.1.
The pump does not start at low output
Increase the output briefly, then lower it after the pump starts.
If the Remote Does Not Respond
Point the remote toward the lamp and move closer.
Check whether the remote battery is installed correctly and still has power.
Open the Wi-Fi app and confirm that Physical Remote is enabled in System.
Make sure the lamp is receiving power.